Monthly Archives: November 2010

Configuring Skeinforge: Making a New Profile.. The Test & Tweak

This article’s the second of two on making up a new profile. If you didn’t read the first one, you probably should do that before reading this one. Or at least scan through it. Even if you’re not making up … Continue reading

Posted in Makerbot, skeinforge | 13 Comments

Configuring Skeinforge: Making a New Profile.. The Setup

Next up is actually creating a new profile.. I’m using Skeinforge 33 for this, dated 10.11.10, but any version close to that should work pretty well. I know 2 ways to dial in a new skeinforge profile. One, the one … Continue reading

Posted in Makerbot, skeinforge | 4 Comments

Configuring Skeinforge: Index to Articles..

Table of contents might be a better term. Either way, I’ve got this series of articles about configuring skeinforge so I figure it’d probably be a good idea to have a single article that references the rest. If you find … Continue reading

Posted in Makerbot, skeinforge | 5 Comments

Configuring Skeinforge: Movin’ on up! (to a recent version)

Starting at ReplicatorG version 0020, the folks at MakerBot are also including a recent version of Skeinforge. w00T!! I’ve been advocating moving up to more recent versions of skeinforge for months now, mostly because I think I can sorta figure out … Continue reading

Posted in Makerbot, skeinforge | Tagged , | 18 Comments